Skip to content

Home
About
Study Pack
Contact
Log In

G3 Quiz 19

G3 Quiz 19

Time limit: 0

Quiz Summary

0 of 10 Questions completed

Questions:

Information

You have already completed the quiz before. Hence you can not start it again.

Quiz is loading…

You must sign in or sign up to start the quiz.

You must first complete the following:

Results

Quiz complete. Results are being recorded.

Results

0 of 10 Questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 point(s), (0)

Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)

Categories

Not categorized 0%

1
2
3
4
5
6
7
8
9
10

Current
Review
Answered
Correct
Incorrect

Question 1 of 10

1. Question
33)what is the method of heat transfer on clothes dryer
- a)radiation
- b)conduction
- c)convection
- d) thermal – ===========c)convection
Correct

Incorrect
Question 2 of 10

2. Question
34)what is the method of heat transfer on a hot plate
- a)radiation
- b)conduction
- c)convection
- d)thermal
Correct

Incorrect
Question 3 of 10

3. Question
35)what is the method of heat transfer on a standard gas fired oven?
- a) radiation
- b)conduction
- c)convection
- d)thermal
Correct

Incorrect
Question 4 of 10

4. Question
36)A yellow flame on an atmospheric burner could be the result of
- a)low gas pressure
- b)insufficient primary air
- c)gas valve
- d)excessive primary air
Correct

Incorrect
Question 5 of 10

5. Question
37)which certificate holder may inspect an appliance with input of 399,000 btu
- a)G1 only
- b)G1 and G2
- c)G2 only
- d)G1,G2, G3
Correct

Incorrect
Question 6 of 10

6. Question
38)where would you find requirements for the holder of G2, G3 certificate
- a)tssa act
- b)ont reg 212/01
- c)OHSA
- d) Ont reg 215/01
Correct

Incorrect
Question 7 of 10

7. Question
39)On a propane gas appliance gas supply pressure before the gas valve shall be?
- a)7" wc
- b)14"wc
- c)11" wc
- d)3.5"wc
Correct

Incorrect
Question 8 of 10

8. Question
40)what is the required minimum distance for plastic piping or tubing installed under a commercial parking lot
- a)12 inches
- b)16 inches
- c)18 inches
- d)24 inches
Correct

Incorrect
Question 9 of 10

9. Question
41)How is a high limit tested on a forced warm air furnace
- a)by disconnecting the air circulation blower
- b)by discontinuing the wires to the limit controls
- c)by disconnecting one air to the thermostat
- d)by shitting off the gas valve to cool the appliance
Correct

Incorrect
Question 10 of 10

10. Question
42)when an appliance is install on a roof of the clearance between the appliance and the edge of the roof or other hazard shall be
- a) 2 ft
- b)4 ft
- c)6ft
- d)10ft
Correct

Incorrect

Copyright © 2023 HVAC Exam Prep